FAAC Gate Repair Nationwide

FAAC Gate Repair in Carrollton: What to Know First

FAAC gate repair in Carrollton is work we do regularly, and most calls are diagnosed and repaired in a single visit. We’re an independent FAAC service provider, not a factory warranty center, which means we can use either OEM or quality aftermarket parts depending on what actually serves the gate and the budget. Pricing is always written and handed to you before any work starts, and most FAAC repairs on Carrollton residential gates fall between $190 and $680 depending on whether we’re replacing a capacitor, a limit switch assembly, or a full hydraulic pump.

Call (817) 778-4585

This page is for homeowners in Carrollton running an FAAC swing or slide gate that’s stopped behaving, gotten noisy, or refuses to close fully. If your FAAC gate is down right now, call (817) 778-4585 and a live person answers.

How FAAC Products Fail - and How We Fix Them

FAAC builds solid hydraulic and electromechanical operators, but every line has patterns. Here’s what we actually find on FAAC gates in Carrollton, not what the manual says should happen.

• FAAC 400 Series (swing gates): oil leaks from the pump body. The 400’s compact hydraulic pump runs hot in Texas summers, and the o-ring between the pump body and reservoir hardens over time. You’ll see a dark stain running down the mounting post. We replace the seal, refill with the correct hydraulic fluid, and pressure-test the unit before we button it up. The fix is typically under $250 if the pump hasn’t run dry.
• FAAC 750 and 760 Series (slide gates): limit switch drift. These gate operators use magnetic limit switches that slide on a rail inside the housing. Vibration from the gate rolling over a slightly rough track can walk the limit switch out of position by a half inch, which is why the gate stops six inches short or overtravels and bangs the end stop. We reset the limits, photograph the new positions, and check the track rollers while we’re in there. If we don’t check the rollers, the switch just drifts again in a month.
• FAAC 844 Series (slide gates): failed capacitors. The 844 is the most common FAAC slide operator we see in Carrollton, and its start capacitor takes a beating during hot afternoons. The symptom is a humming operator that won’t move the gate, or a gate that starts moving and then stalls midway. A new capacitor is a $40-to-$90 part. We test the old one before replacing it, because a humming motor can also mean a seized gearbox if the operator has been flooded at the base.
• FAAC 620 Series (barrier arms and light swing gates): broken limit microswitches. The 620 uses small mechanical microswitches that crack at the solder joint after a few years of vibration. The gate will open fine and then refuse to close, or vice versa. We replace the microswitch with a properly rated component and adjust the stop cams, then run the gate through twenty full cycles to confirm the limits hold.
• FAAC E024U control boards: water intrusion at the wire entry. Carrollton gets real rain in spring and fall, and the low-voltage wire entry on the E024U board is the weak point. When the grommet isn’t seated or the conduit bell end cracks, water wicks inside the housing and corrodes the relay terminals. The board may behave intermittently – working in the morning, dead by afternoon – before it fails outright. We dry the enclosure, replace any corroded terminals, and reseal the entry point with duct seal and a drip loop so the failure doesn’t repeat.

Our FAAC Gate Repair Process

Every FAAC job we run in Carrollton follows the same sequence, because the sequence is the safeguard. Here’s what happens from the call to the final leave-behind.

1. 1
   Dispatch and identification. You call (817) 778-4585. A live person answers, we take the address and the symptom, and the technician arrives with your gate’s make and model already noted. You get the tech’s name and photo before arrival.
2. 2
   Diagnostics with documentation. We open the operator, check power delivery, test the capacitor and transformer, and probe the limit circuit. Every reading gets written down. The limit switch position is photographed before we touch anything.
3. 3
   Written price before any repair. Once we’ve found the failure, we hand you a flat price for the parts and labor. You approve it, or we stop and you owe only the service call. There is no version of this where we start work and you discover the price at the end.
4. 4
   Parts decision, made transparently. On FAAC boards and motors, we’ll quote OEM parts unless there’s a proven aftermarket equivalent that carries the same behavior. We’ll tell you which is which and why, and the price difference in dollars. You decide.
5. 5
   The repair and the test. We install, adjust, and then put the gate through repeated open-close cycles with weight on the arm. If it’s a swing gate, we check force settings and photo-eye alignment. If it’s a slide gate, we check track and end stops.
6. 6
   Documentation and guarantee. Before we leave you get a written record of the part number installed, the readings we found, and photos of the work. Your repair is covered by the 365-Day Done Right Promise: if it’s not right, we make it right, no charge, for a full year.

Before

After

What FAAC Gate Repair Costs in Carrollton

We get asked this question more than any other, and it deserves a straight answer. Here are the ranges we’ve charged for common FAAC repairs on Carrollton residential gates over the past few years.

• Start capacitor replacement: $120 - $210
• Limit switch or microswitch replacement and re-adjustment: $150 - $260
• Photo-eye realignment or replacement pair: $140 - $290
• Hydraulic pump seal replacement (FAAC 400 Series): $190 - $380
• Control board rebuild of relay contacts (not full replacement): $180 - $300
• Full control board replacement (E024U or similar): $450 - $780
• Complete FAAC operator replacement, installed: $1,800 - $3,400 depending on model and gate weight

What moves the price: the model you have, whether the operator housing is wet, whether the mounting post or gate hinges have shifted, and whether we can rebuild a component or must replace it. We’ll tell you the repair range on the phone, and the exact written price before work starts. Call (817) 778-4585 for a free estimate on your specific gate.

Why Carrollton Homeowners Call Vance Gate Repair Carrollton for FAAC Work

Most of the FAAC gates we repair in Carrollton were installed by someone who is no longer in business or no longer answering the phone. That leaves the homeowner with a branded operator, a fading memory of who put it in, and no documentation of what was done. We fix that by documenting everything. Since 2014, Adrian Vance and our technicians have repaired and installed over 22,000 gates, every one with a written price before work and a photo record when the job was done.

We also work on the other brands sitting in Carrollton driveways: LiftMaster, Mighty Mule, Ghost Controls, and DoorKing. If you have a mixed setup or you’re not certain what operator you have, that’s fine. We’ll confirm the brand and model on the phone before dispatch. The point is to repair the gate you own, not to sell you one you don’t need.

Every FAAC repair is covered by our 365-Day Done Right Promise. If the same fault comes back within a year, we make it right with no fee and no argument. That’s the entire agreement. A live person answers our phones around the clock, because a gate that won’t close at 11 p.m. is not a problem that waits for Monday.

FAQs